For many, a shower hose just sits there, doing what it’s meant to do – supplying water from your shower head to the rest of the shower. But how often do you actually think about the condition of your shower hose? Probably not very often, since you’re too busy enjoying your bathroom time and getting clean! But if you have any concerns, don’t worry – it’s easy to change a shower hose, and it won’t take you long at all. Read on to find out how to disconnect your old hose, and how to fit a new one.
1) Turn Off The Water
The first step is to turn off the water at the main valve. Once you’ve done that, take the shower hose holder off the wall by loosening it with a screwdriver. If you can’t find your shower hose holder, then look for a nearby spot where there is a hole coming out of the wall. It will be duschslang mora with a black rubber cap, so pry it off with your fingers or a pair of needle nose pliers. Once you’ve removed this cap, use a towel to soak up any water that is coming out of it. Now you’re ready to disconnect your old shower hose from the fitting on your shower head.
2) Remove The Old Hose
First, disconnect the old shower hose by twisting it until it pops free. Make sure that you twist it in the opposite direction to how it is currently attached. Next, take a towel, fold it up and put a rubber band around one end of the folded-up towel. Once that is done, insert your rubber-banded end into the opening of your bath shower hose connector.
3) Connect The New Hose
After disconnecting your old faulty shower hose, it is time to connect the new one. Get a few feet of the pipe clear from any kinks and make sure the ends are facing away from each other. Put your mouth over the end of the pipe that faces you, then hold both free handdusch med avstängning together with your hands. Gently blow out through your mouth to inflate the pipe, giving it shape and stability so that you can easily fit it into place. Now, turn your back to the end that is not connected to water, then feed one end over to where you will be connecting it, making sure not to pinch or bend any of the pipes as you do so.
4) Test For Leaks
The first step to changing a shower hose is locating the pipe that connects your new hose to the valve. Most pipes are going to be located either on the side of your bath or at the back. Look for a little plastic plug that screws off and it will give you access to the pipe. Next, find where the other end of your old hose connects up to the pipe, with a nozzle over it if possible. Use a wrench or pliers to unscrew this connecting piece so that you can get it out of there for good. Now take hold of your new fitting shower hose and gently screw it on at a slight angle – make sure it’s sitting tightly in place but still able to move around without coming loose.